This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
electronics:rx:techinfo:documentation_2_8cm_rx_s28mm [2019/12/13 11:52] ubach created |
electronics:rx:techinfo:documentation_2_8cm_rx_s28mm [2021/04/15 16:37] (current) rkeller |
||
---|---|---|---|
Line 1: | Line 1: | ||
===Technical Documentation of the 2.8 cm Receiver 10.3 - 10.6 GHz (S28mm)=== | ===Technical Documentation of the 2.8 cm Receiver 10.3 - 10.6 GHz (S28mm)=== | ||
- | ||Type|HEMT cooled || | + | |Type|HEMT cooled | |
- | ||Channels|4 || | + | |Channels|4 | |
- | ||Receiver Noise|50K || | + | |Receiver Noise|50K | |
- | ||Frequency range|10.3 - 10.6 GHz || | + | |Frequency range|10.3 - 10.6 GHz | |
- | ||Polarization|LHC/RHC | 2 horns|| | + | |Polarization|LHC/RHC | 2 horns| |
- | ||Calibration|Noise diode || | + | |Calibration|Noise diode | |
- | ||Polarimeter | Broadband Polarimeter || | + | |Polarimeter | Broadband Polarimeter | |
- | ||1st IF|2.2 - 2.3 GHz | || | + | |1st IF| |2.2 - 2.3 GHz | 2.4 - 2.8 GHz | |
- | || LO1|Valon 5009| fsynt.1 = 4.15 GHz x 2 |(preset 8.3 GHz) | || | + | | LO1|Valon 5009| fsynt.1 = 4.15 GHz x 2 |fsynt.1 = 3.925 GHz x 2 | |
- | ||2nd IF|100 - 200 MHz | | || | + | |2nd IF| |100 - 200 MHz |600 - 900 MHz | |
- | || LO2|Valon 5009| fsynt.2 = 2.1 GHz |(preset 2.1 GHz) | || | + | | LO2|Valon 5009| fsynt.2 = 2.1 GHz |fsynt.2 = 1.85 GHz | |
{{:electronics:rx:techinfo:2.8cm_rx_bsb_einfach.jpg?900|}} | {{:electronics:rx:techinfo:2.8cm_rx_bsb_einfach.jpg?900|}} | ||
- | Simplified {{:electronics:rx:techinfo:2.8cm_rx_bsb_einfach.pdf|Block Diagram}} of the receiver, (RK on 24.4.2018) | + | Simplified {{:electronics:rx:techinfo:2.8cm_rx_bsb_einfach.pdf|Block Diagram}} of the receiver, (RK on 14.4.2021) |
+ | |||
+ | {{ :electronics:rx:techinfo:einstellungen_s28mm_für_versionen.pdf |Here}} you can find a table with the settings needed to get access to the IF (in German). | ||
==Comment== | ==Comment== |