Differences

This shows you the differences between two versions of the page.

--- electronics:rx:techinfo:documentation_p26mm [2019/12/17 09:43]
rkeller
+++ electronics:rx:techinfo:documentation_p26mm [2021/03/16 15:04]
rkeller
@@ Line 7: / Line 7: @@
 |Polarization|LHC |
 |Calibration|Noise Diode after 1. Amplifier|
-|1. Oscillator|ULO1 x 6|
+|1. Oscillator|LO1 = (HSM12001 in PM1)|
 |1. IF|0 - 300 MHz|
-====== Block Diagram ======
-{{:electronics:rx:techinfo:p300mm_block_diagram.jpg|}}
+**Block Diagram**
-**Commenets**
+{{:electronics:rx:techinfo:bsb_p26mm_holo_20210316_ohnerahmen.jpg?1200|}}
->The noise measurements were made in the laboratory with 2 MHz bandwidth and refer to the feed.
-This system was constructed particularly for VLBI, but was already used during test measurements also for spectroscopy, continuum and pulsar observations. This frequency range is not free of interference. Observers wanting to do continuum or pulsar observations might have to search for a frequency range not obstructed by interference and/or use a narrower bandwidth.
+{{ :electronics:rx:techinfo:bsb_p26mm_holo_20210316.pdf |Block Diagram}} of the P26mm
-This system is part of Primary Focus Multi Frequency Box #2 (PM2).
+**Comments**
+This system was constructed particularly for holography measurements of the main dish and is restricted in band width.
+This system is part of Primary Focus Multi Frequency Box #1 (PM1).

Effelsberg 100m Teleskop