User Tools
information_for_astronomers:user_guide:signalpathsetup
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
information_for_astronomers:user_guide:signalpathsetup [2014/11/21 10:40] bwinkel |
information_for_astronomers:user_guide:signalpathsetup [2014/11/21 10:56] bwinkel |
||
|---|---|---|---|
| Line 7: | Line 7: | ||
| <code>SXXNNNZ</code> | <code>SXXNNNZ</code> | ||
| - | where XX stands for the channel which one would like to change and NNN is a three-byte code for the mode. XX can be 01 to 16, or 99 (for all channels. Typical modes are: | + | where XX stands for the channel which one would like to change and NNN is a three-byte code for the mode. XX can be 01 to 16, or 99 (for all channels. **Note, that the MultiFiBa got a very slow processing unit, so sometimes it may take a while until the requested mode is set.** Typical modes are: |
| ^Mode^Channels^IF name^IF range^Bandwidth^Attenuation^Comments^ | ^Mode^Channels^IF name^IF range^Bandwidth^Attenuation^Comments^ | ||
information_for_astronomers/user_guide/signalpathsetup.txt ยท Last modified: 2017/01/25 20:24 by akraus
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
