This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
information_for_astronomers:user_guide:tutorials:4mtelescope [2018/09/18 11:27] schweikert [Bugs] |
information_for_astronomers:user_guide:tutorials:4mtelescope [2018/09/18 11:43] (current) schweikert [Bugs] |
||
---|---|---|---|
Line 130: | Line 130: | ||
* __**Telescope still not moving, optionally giving error messages**__ | * __**Telescope still not moving, optionally giving error messages**__ | ||
- | If a crossscan was started close to the hardcoded Azimuth endpoints of the telescope, it is possible that the telescope crossed over this endpoint. This means the actuator controls will have to be manually restarted take a look at section Limit Position exceeded (F6029 Lagegrenzwert überschritten). | + | If a crossscan was started close to the hardcoded Azimuth endpoints of the telescope, it is possible that the telescope crossed over this endpoint. This means the actuator controls will have to be manually restarted take a look at section Limitposition exceeded (F6029 Lagegrenzwert überschritten). |
* __**Multiple backends online at the same time, don't turn off on restart**__ | * __**Multiple backends online at the same time, don't turn off on restart**__ | ||
Line 149: | Line 149: | ||
{{ :information_for_astronomers:user_guide:tutorials:indraworksfoundhardware.png?500 |}} | {{ :information_for_astronomers:user_guide:tutorials:indraworksfoundhardware.png?500 |}} | ||
- | If you connect to the hardware, the following window appears. Select the unit. | + | If you connect the hardware, the following window appears. Select the unit. |
(134.104.79.88 -> Elevation) | (134.104.79.88 -> Elevation) | ||
Line 169: | Line 169: | ||
__**Attention:**__ | __**Attention:**__ | ||
- | Both Achsstatus must show „A0012 Steuer- und Leistungsteil betriebsbereit“. In addition it's only possible to communicate with the IndraWorks Ds or with the Controlsystem. If you want to control the teleskop with the Controlprogram you need do close IndraWorks Ds. | + | Both Achsstatus must show „A0012 Steuer- und Leistungsteil betriebsbereit“. In addition it's only possible to communicate with the IndraWorks __or__ with the controlsystem. If you want to control the teleskop with the controlprogram you need to close IndraWorks. |
- | * __**Limit Position exceeded (F6029 Lagegrenzwert überschritten)**__ | + | * __**Limitposition exceeded (F6029 Lagegrenzwert überschritten)**__ |
- | Open IndraWorks Ds and search the units. __**Attention:**__ You need to close the controlsystem, because it's only possible to communicate with Indraworks __or__ the controlsystem. | + | Open IndraWorks and search the units. __**Attention:**__ You need to close the controlsystem, because it's only possible to communicate with IndraWorks __or__ the controlsystem. |
Choose the unit: | Choose the unit: |