- Information for Astronomers
- General Topics*
- Gruppen Seiten*
* Log-in required
* Log-in required
This is an old revision of the document!
This broad-band system is mainly used for VLBI observations. Be aware, that this band may be influenced by RFI (especially below 1 GHz). In 2011 a new satellite was lunched by NASA, Aquarius, that uses a radar from 1220 MHz to 1280 MHz to measure the roughness of the oceans surface. During its 10-15 min passage over Effelsberg every 7 days the receiver will be most likely saturated. More information about the satellite and when it actually passes Effelsberg can be found on the following page: Aqurius Mission page by NASA and Visible passes over Effelsberg.
|Frequency [GHz]||Channel||Polarisation||Tcal [K]||Tsys [K]||Sensitivity [K/Jy]||SEFD [Jy]||Aperture Eff. [%]||TMB/S [K/Jy]||Main Beam Eff. [%]||FWHM [arcsec]||Last update|
|normalized Gain curve (G = A0 + A1·Elv + A2·Elv2)||Observed in||confirmed|
|A0 = 1.0 A1 = 0.0 A2 = 0.0||Sep 2008||Nov 2012|
|RX Name||Wavelength [cm]||Frequency (center) [GHz]||Nr. of Horns|
|P300mm 4-box||30||0.8-1.3 (1.05)||1|
|1. Cont/Line (BW: 100 MHz)||Narrow band Continuum|
|2. Pulsar (BW: 100 MHz)||Narrow band Continuum pulsar setup|
|Horn offsets [arcsec]||-988.7, 999.7|
The Horn offset result from the offset position in the prime focus multi-receiver-box II.
Note that the narrow line and VLBA IF channels are usually only available when the specific line version of the receiver was selected. In addition for most receivers with narrow line channels the cables at the patch board need to be connected by the receiver group.
To select different channel numbers in OBSINP, the online plot, or the toolbox the numbers have to be specified like c(1)+c(2) to add channel 1 and 2. E.g. channel 1 and 2 contain the LCP and RCP broadband channels, then "OnlPlot pen='c(1)+c(2)'" or "toolbox use='c(1)+c(2)'" will select these channels. In OBSINP the pen can be directly specified in the receiver selection menu.
SB: narrow band channel (Schmalband-Kanal), 100 MHz band width
BB: digital broad band channel (Breitband-Kanal), band width varies for different receivers
VLBA: VLBA IF, 500 MHz band width
BW: band width
TP: total power
|30cm PFK (Multi-RX-Box II)|